DSO6022BL Platform 6000

Overview:

DSO6022BL USB 2.0 interface, does not require external power. Suitable for use with laptop computers. Aluminum housing that can be positioned horizontally or vertically. Size (mm): 205 (length) x 120 (width) x 35 (height). 23 measurement functions. Emulation of an electronic phosphor, addition, subtraction, multiplication, division, XY graph. Saving a signal in the following formats: text, jpg / bmp, MS excel / word file. FFT You can connect multiple devices to one computer.

This model is the development of the 6022BE model. The oscilloscope parameters are exactly the same as those of the 6022BE, but a 16-channel logic analyzer is added, with a band of up to 10 MHz, a sampling frequency of 48 MHz and a memory of 1M measurements. This is more than enough for viewing low-speed data buses. Limitations of the model: the oscilloscope and analyzer do not work together or the oscilloscope or analyzer. No tire analysis.

What's more?

The bandwidth depends on the selected volt / division value.

The maximum input range without a divider is from -4.5 to +4.5 volts. When exceeded, the signal will not only be cut off, but inverted and shown in reflection.

In addition, she does not have a closed input (AC coupling). Those. the constant component will always be at the input. This can be circumvented by independently passing the signal through the capacitor.

The official software is quite limited, but in the support / download section you will find third-party software with advanced features.

There is no external synchronization in this device. The amount of memory depends on the selected time / division and is not set manually.

Features

Interface USB 2.0, does not require external power.

Suitable for use with laptop computers. Aluminum case.

Size (mm): 205 (length) x 120 (width) x 35 (height). It can be located both horizontally and vertically. Occupies a minimum of table space.

OS: Windows XP, VISTA, 7.8.

Saving a signal in the following formats: text, jpg / bmp, MS excel / word file.

You can connect multiple devices to one computer

Attention! When measuring voltage, correctly set the attenuator on the probe! Too much measured voltage will damage the device and endanger you and the connected computer. Do not measure voltages greater than 35V in 1X probe mode!

Completeness:
Device -1pcs
USB cable - 1pcs
Probes -2pcs
Software